IMPORTANT DESIGNS STANDARDS
FOR ALL FLEXIBLE DOORS.

To enhance the life of any impact
operated flexible doors it is strongly
recommended that, where mechanical
or hand operated traffic is used, door
opening should be approximately 10%
higher and 30% wider than the size of
equipment passing through the opening.
 

FOR OPENINGS LARGER THAN STANDARD.

DESIGN FEATURES OF YOUR SWINGFLEX® DOOR MK6.

Heavy duty zinc plated steel head plates and high tensile steel bolts, clamp the PVC sheet to distribute the stress over a large area.

PVC retaining seams are integrally welding to the top edge, and sealed on top of the head plates to prevent any possible sagging of the PVC.

Also formed in the head plates is an anti-tear flair at the bottom edge and a projected forming to act as a skid bar on accidental impact.

Vertical stiles of strong extruded aluminium section, and anodised for extra protection and appearances. The PVC sheet, either 7mm or 10mm in thickness, is held in place by two full length welded seams captivated in the extruded stile.

Door openings with a height in excess of 3000mm, transome flaps can be fitted above the doors. Where the width exceeds 3000mm wide, a dual spring model is recommended.

The unique hemispherical bottom support pivot enables easy installation. Even with misaligned floors or door jambs, it guarantees effortless opening.The adjustable jack located in the stile is used to correct the door height after installation.